1 ocena klienta po polski dla BIQU H2O Extruder
2 recenzje klienta w innym języku
4,7 z 5 gwiazdek
5 gwiazdek | | 2 | (66%) |
---|---|---|---|
4 gwiazdki | | 1 | (33%) |
3 gwiazdki | | 0 | (0%) |
2 gwiazdki | | 0 | (0%) |
1 gwiazdka | | 0 | (0%) |
Filtruj opinie:
Nowe artykułu na blogu:
Odkryj 3DJake:
-
Darmowa wysyłka
do Polska od 229,00 zł -
Darmowa
wysyłka zwrotna -
Otrzymasz przesyłkę w ciągu 2 dni.
Więcej niż 9.100 art.
Pay attention for Compatability!
oceniony 4 z 5 gwiazd.
Use this printer head with water pump from same maker for 3 month and face numerous problems during installation due to issues with motherboard installed at my printer. If you see your ptinter in compat. list you'd better double check with maker directly.
As printing head itself is very good. GCODE required small adjustment to avoid problems with extrusion as its ratio is 7:1 and extrusion step amnt for 1 mm 963 (as manufacturer) but i am using 960. Mechanism - OK, tube a little bit soft but looks durable. High quality assembly.
Remarks for seller, please review compatability list and make remark that it is require setup of MAX31860 controller and compatable motherboard. Also remarks that this controller compatable with motherboards which contains free slot of stepper-like PCB connector. Istallation of MAX31860 controller with PT100 temp. sensor is a bit difficult procedure for motherboard without appropriate firmware available, free ports and so on. E.g. CRELITY MOTHERBOARD V2.2 SILENT (which is typical for mostly new fabricated printers)is not compatable with this controller directly and you should have good knowledge of Marlin to connect MAX31860 through available pins available on motherboard. In conclusion, this system will work with 50w heater (max.temp. 300) and standard thermistor couple. If you need 500C hot end, you should be very well familiar with setting up and compiling the Marlin firmware.
Czy ta ocena była pomocna? (0) (0)